English
English
8
OPERATING INSTRUCTIONS
Before first use
Before first operation:
1. Adjust the water hardness, see chapter below.
2. Pour 500ml of water into the salt dispenser and fill it with dishwasher salt.
3. Fill the rinse aid dispenser.
4. Fill the detergent dispenser.
Setting the salt consumption
The dishwasher allows to regulate the consumption of salt depending on the hardness of the water used.
Thus can be the salt consumption optimized and regulated. When regulating the salt consumption, proceed
as follows:
Salt dispenser can be set from H0 to H7, when setting is H0, the salt is not dispensed.
Determine the hardness of your water (this information can be obtained from your water supplier), and set the
dose according to water hardness table:
1. Close the door.
2. Turn on the dishwasher using the button “Power”.
3. Hold the button “Delay” and then press for 5 seconds the button “Program”. An acoustic signal sounds and
the display flashes H (factory setting is H4).
4. Press the button “Delay” to change the setting. The value of the dose increases by 1 level with each
pressing of the “Delay” button. After reaching H7, it jumps with next pressing of the “Delay” button to H0
(dispensing is off).
5. Press the button “Program”. The setting is saved in the memory of the appliance.
Water hardness table
Water hardness
mmol/l
Set value
°Clark
Hardness
0–8
soft
0-1.1
H0
9–10
soft
1.2-1.4
H1
11–12
medium
1.5-1.8
H2
13–15
medium
1.9-2.1
H3
16–20
medium
2.2-2.9
H4
21–26
hard
3.0-3.7
H5
27–38
hard
3.8-5.4
H6
39–62
hard
5.5-8.9
H7
Note:
•
The water hardness can vary in each area.
•
If hard water would be used, deposits would form on the dishes and cutlery.
•
The appliance is equipped with a special water softener using salt dispenser designed to remove calcium
and other minerals from the water.
Addition of salt to water softener
The salt dispenser is located under the bottom basket. Fill it according to the following description: