49
EN
Programming
You can program playback of at least 20 tracks in any order.
1. Insert CD or connect USB, where are tracks which you want to program.
2. Make sure that the playback stopped (press
x
).
3. Press
MODE
(
PROGRAM)
. The display will show “
P01
” and the indicator
PROG
will start fl ashing.
4. Using
the
.
/
>
buttons, select the desired track.
5. Press
MODE
to save the selection.
6. Repeat steps (4) and (5) until you enter all your desired tracks.
7.
If you want to play the tracks from the created program, press the
u
button.
8. The device stops automatically after all the programmed tracks are played.
Notes:
•
The memory is full after programming 20 tracks of an Audio CD (or 99 tracks of MP3 CD or USB drive) and
the display shows “FULL”.
•
If you want to delete the program, press the
x
button, while the playback is stopped. You can use the
functions “REP” and “REP ALL” with the program as well.
Repeat the programmed tracks
1. During program playback, press
MODE
once, to repeat a particular track of the program.
2. When you press the
MODE
button again, you can repeat all the programmed tracks.
3. Press
x
to cancel repeat playback of the programmed tracks.
Power save (APS automatic off system)
The device goes into standby mode in 15 minutes in the following situations:
•
The device is set to CD mode and there is no disc in the disc tray or the playback is stopped.
•
The device is set to USB mode and there is no USB memory device connected to the player or the USB
playback is stopped.
•
The device is set to AUX mode and there is no audio cable connected to the AUX IN jack.
Press
STANDBY
button once to switch the player back on.
CARE AND MAINTENANCE
Care of the cabinet
•
Unplug the device from the outlet before cleaning. You will avoid risk of fi re and injury by electric shock.
•
You can clean the surface of the device using dust cloth. Be cautious when cleaning and wiping the
plastic parts.
•
You can use cloth dipped in a weak detergent solution to clean the front panel.
Lens cleaning
•
A dirty lens may cause skipping of the disc or make it impossible to play it entirely.
•
Open the disc tray door.
•
Use blower brush for cleaning, designed to clean camera optics. Blow once or twice on the lens, remove
dirt from the lens with the brush and blow again on the lens.
•
To remove fi ngerprints, use dry cotton swab. Clean the lens from the center toward the edge.
