Support:
Support.Eccotemp.com
Shop Online:
Eccotemp.com
Store Locator:
Eccotemp.com/locator
10
ENGLISH
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
AND ALL AIR IS REMOVED.
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Installation Instructions
Water connections should be in close orientation to the install site. Confirm there is
enough allowance for the water intake and outake hoses to reach the water heater.
Note
: If your water pipes are copper or bronze be sure to use dielectric
connections to prevent corrosion. Failure to do so may cause damage to your
tank and void your warranty. In order to protect the water heater from heat
damage due to soldering, solder a piece of tubing to a threaded union fitting
before screwing the union to the tank.
1. Install a shut off valve in line with the cold-water pipe.
2. Connect the cold water pipe to the inlet nipple, marked with a blue label.
3. Connect the hot water pipe to the outlet nipple, marked with a red label.
WATER CONNECTIONS
View of the Top
Cold Water Connection
1/2 Inch NPT
Hot Water Connection
1/2 Inch NPT
NOTICE: Do not attempt to remove rubber washer.
Temperature & Pressure
Relief Valve 3/4 Inch
IMPORTANT: Failure to provide dielectric insulation may result in premature tank
or nipple failure and may void your warranty. The Temperature & Pressure Relief
valve (T&P valve) is for servicing and the valve should be in the open position
when the water heater is in operation. DO NOT APPLY HEAT DIRECTLY TO INLET
OR OUTLET CONNECTIONS.
Front
INST
ALL
ATION