Page 6 of 15
Buzzer
Extension
DC Power
Trigger Input
& Alarm Output
RED-(12-24VDC)
BLACK-GND
WHITE-Trigger Input(active:12-24VDC)
YELLOW-Alarm Output
Control box (Powered by the POWER red wire and GROUND black)
Ignition
or battery power
+
-
Camera Cable
(Included with Camera Kit, sold separately)
Camera
(sold separately)
Sensor
External Backup alarm
or light beacon
(sold separately)
Monitor
(sold separately)
Video
Output
Monitor Transition Cable
VIDEO INPUT
6.2.2 Radar System with Camera System:
Figure 7
CONFIG SHOWN: EC1011 SINGLE RADAR KIT W/ CAMERA
& MONITOR
NOTE: This is a switched ground output.
1A max. Isolate if not used.
Port A for monitor (use a plug sealer for IP protection)
Port B for buzzer (Buzzer/Configuration)
Port C for radar sensor (through 3m Sensor Transition Cable for one sensor. Use an additional 0.25m Dual Sensor Transition Cable for two
sensor (optional).
Figure 8
Connecting two sensors (EC1012 Dual Radar Kit)
Port D for camera (through camera cable that comes with the camera, sold separately)
Port E for power and trigger cable (through 1.5m power cable and trigger cable)
Red wire: connect to power of the system’s power supply
Black wire: connect to ground of the system’s power supply
White wire: trigger input
Yellow wire: alarm output
Trigger Input:
Alarm Input:
The system provides an auxiliary input that allows an external signal input to change the sensor status between standby and active.
The input is wired to the reverse circuit of the vehicle.
The system provides an auxiliary output that triggers an external device whenever the sensor detects an object. This output can be
used to activate an exteranl backup alarm or a light beacon. The output is switched from a high impedance state to ground when
activated and is protected against over-current or short-circuit. The maximum operating current is approximately 1 amp. The power
supply for alarm cannot exceed 24V.
