PX200NB
–
Manual
Page 12 / 57
remote control button program in the communicator memory. LED turns off to exit
the programming mode.
•
After the second STATUS LED flash, the communicator will enter the
programming mode the channel is responsible for virtual input #10. Status LED on.
Pressing the remote control button program in the communicator memory. LED turns
off to exit the programming mode.
•
After the third STATUS LED flash, the communicator will enter the erasing
mode. Press the PROG button again and wait to LED STATUS off. Release the button.
Erasing of pre-programmed remotes will be confirmed by lighting up STATUS LED and
OK.
