EBS EBS-230, User Manual, Page: 62 / 64

EBS-230
Printer User's Manual
60
___________________________________________________
20080512#1.0
5.2. Transporting the Printer
The printing system should be transported in its regular working position. This applies in particular to
the printer itself and the ink system. Avoid any excessive shocks or vibration.
If there is a threat that the entire printer may get tilted or be exposed to excessive shocks or vibration
during the transportation, secure the unit in the following way:
1. Detach and remove the printer from its workplace.
2. Remove the bottle of ink and plug it with an original cap to protect the ink from pouring out.
3. Uninstall the printer, dismantle the ink system, distributor and its connection cables.
4. Protect the printer as for storage – see section
5.1 Storing the Printer .
5. Wrap parts of the printing system (the printer, ink system carrier, bottle carrier and printer fixtures
and holders, distributor) with corrugated board or bubble foil.
6. Wind up connecting cables and polyethylene tubes to make a reel of the diameter of about 20 cm
and secure with packing tape.
7. Place all secured parts in a cardboard box (the original transportation packing is recommended)
and protect them against relocating inside the box. Close the box and protect it from getting open
accidentally. Other packing can also be used to protect all parts against mechanical damage.
Allowable mechanical shocks inside the packing must not exceed
the maximum of 1g over the
maximum of 2 ms .