Q3
EN
22
www.eberg.eu
Louver
oscillation
Press the button
to start the automatic airflow direction change function -
louver oscillation. Press this button again to disable this function.
Set
Temperature
Mode.
The Tempera-
ture Setting
symbol lights
up constan-
tly.
1. Press the button
, to start the temperature setting
process. The temperature value flashes. Press the “+” or “-” button
to set the desired temperature. Temperature setting range:
18-45 °C.
Button “-”,
If the set temperature is lower than or equal to the ambient
temperature, the heater will not work in heating mode.
Note: When the set temperature is lower than or equal to the
ambient temperature, the unit will stop heating and the fan will
stop after 30 seconds, the heating mode symbol flashes, the
louver stop, the louver oscillation function light flashes, other
functions can be set as normal.
Button “+”,
If the set temperature is 1-2 ℃ higher than the ambient
temperature, the heater will work in heating mode in the first
speed (1000W).
If the set temperature is 3 ℃ and more than the ambient
temperature, the heater will operate in full power heating mode
(2000W).
2. Confirm the set temperature by pressing the OK button or after
5 seconds without changing the settings.
Open Window
Detection
Function
(sudden drop
in tempe-
rature in the
room)
When the
open window
detection
function is
active, the
set temper-
ature symbol
flashes.
1. Open window detection can be activated only when the device
is in the heating mode (this function cannot be activated when
only the fan is working - air circulation) or in the set temperature
mode.
2. Press the button
to activate the function of detecting
an open window (sudden drop in room temperature). Press this
button again to turn this feature off.
3. The temperature control as an open window function will start
1 min. after activating this function.
The temperature is controlled in 10-minute cycles. Details are
presented in the table below.
