Q3
EN
18
www.eberg.eu
•
WARNING: To minimize the risk of fire, keep textiles, curtains, or other flammable material at least 1m
away from the air outlet.
•
The remote control has a battery. Be especially careful.
•
KEEP THE REMOTE CONTROL AND BETTERIES OUT OF REACH OF CHILDREN. Ingestion can
lead to chemical burns, soft tissue damage and death. Severe burns may occur within 2
hours of ingestion. If a child swallows a battery, consult a doctor immediately.
•
Do not let children change the batteries in the remote control.
•
Do not short circuit the battery.
•
Do not heat the battery.
•
Remove the batteries from the remote control if the device will not be used for a long
period of time.
•
Always select the correct size and type of batteries for the use in the remote control.
Information supplied with the device regarding the correct selection of batteries should
be kept for reference.
•
Before installing the battery, clean the battery contacts as well as the contacts on the
remote control.
•
Make sure the batteries are installed correctly with respect to the polarity (+ and -).
•
Remove exhausted batteries immediately, do not leave them in the remote control.
•
Do not throw the battery into a fire.
•
Batteries must be disposed of via your municipal waste disposal service.
2. DEVICE FEATURES
1.
High-quality plastic housing and glass front panel ensure long life of the device.
2.
PTC ceramic heating element: high efficiency heating, fast heating, noiseless, odorless, non-
polluting, no flame, no oxygen consumption in the room.
3.
Two-level setting of the heating power. You can set the temperature according to your preferences.
4.
The heater is equipped with a temperature fuse to prevent possible overheating of the device and
to protect the engine from overheating. The heater will automatically turn off when the air outlet is
blocked and will turn on again when the air outlet is unblocked.
5.
Air supply with cool or heated air. You can turn off the heating element. In summer, the device can
be used to circulate air in the room.
6.
Safety thermostat. Overheating protection.
3. DEVICE ASSEMBLY
•
Drill two holes in the wall at a minimum height of 2m from the floor and a minimum distance of
30cm from the ceiling. The distance between the heater and the walls on the sides of the device
should not be less than 30 cm. The diameter of the expansion plug is 6mm. The spacing of the holes
is 315mm.
•
After placing the wall plugs in the drilled holes, screw in the screws. Do not screw in the screws all the
way, the screw heads should protrude from the wall by 10mm.
•
Hang the device on the screws protruding from the wall. Then move the device in such a way that
the bolt heads move from position A to B. This will cause the device to hang securely and safely on
the bolts.
•
If you want to disassemble the heater, move the device so that the screw heads move from position
B to A, then remove the device from the screws.
•
See the pictures below.
