EPD 50 | EPD 70
EN
32
www.eberg.eu
7.Overload Protection
In the event of a power loss, to protect the compressor there is a 3-minute delay until the compressor
restarting.
8. Memory Function
The system has auto memory. When all the mode setting has been finished, if there is sudden power cut
during operation, or the power jack slips out, the system may store the current status before the power is
cut and enter the operation mode before power cut automatically after power is supplied.
5.3. DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
5.3.1. EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once you
empty the water tank and installed properly.
1. When the tank is full, the “FULL” light will turn on.
2. The unit will make a buzzing sound. Press the power button to turn off the machine.
3. To empty the water tank, open the front panel to access the water tank.
4. Grab the handle of the water tank and pull it out horizontally.
5. After disposing of the water, replace the tank and close the front panel.
6. Press the POWER button to resume operation.
5.3.2. CONTINUOUS DRAINING
For continuous operation or unattended dehumidification, please connect the attached drain hose to the
unit.
1. Press the POWER button to turn off the machine.
2. Open the front lower cover; remove the water tank from the unit.
3. Push the drain hose through the continuous drainage opening and connect one end to the hose con-
nection.
