Eazao Zero, Instruction Manual

Page: 45 / 50

TROUBLE SHOOTING
9.1.2 Connectivity Problems.
My 3D Printer isn’t turning on
Check that you have correctly inserted the power cable into the rear of the Control Box,
the power cord is plugged into the mains outlet and that the Control Box power switch
is on.
SD Card not shown
•Please ensure your SD Card is 2GB or less.
•Please ensure your SD Card is formatted as FAT32.
•Navigate SD Card, select Unmounts SD Card, then select Mount SD Card. Your SD Card
should now appear in the menu.
9.1.3 Other Problems.
Display
Provides the main interface for operating the 3D Printer.
Firmware
Software that is programmed into the electronic board.
GCODE
Code that is produced using the slicing process. Describes the movements and extrusion
settings of your 3D printer.
Needle
Opening at the bottom of the print head where clay is pushed through.
SD Card
Secure Digital memory card. This is where your GCODE files can be stored and accessed
by the 3D Printer.
Slicing
Process that turns a 3D Design into a code that can be used by 3D Printers.
Stepper Motor
Stepper motors that move in discrete steps. This allows for precise positioning and/or
speed control.
36