5.1.3 Extruder diagram.
SERVICING
1. Extruder Tailstock
2. Sealing Ring
3. Extrusion Screw
4. G 1/2 Tube Quick Connect
5. Extruder Shell
6. Needle Adapter
7. Needle
Note:
1. After each use, be sure to clean the extruder and tube.
2. Rotating 1-extruder tailstock and 5 extruder shell can separate the two, and
clean the screw and the inside of the extruder shell. Clean the sealing ring
at the same time. After cleaning, proceed assembling in the order shown
above.
5.1.4 Introduction of electric putter "extrusion" interface.
1.
BackPutter
-Electric putter back function
When you need to start printing or replace the cartridge, make sure that the electric
putter is in the back position and use the electric putter back function.
① .
To select the stroke, click the button "10-200-2000" twice to make the pointer stay
in the 2000 gear.
② .
To select the working mode, click the button "BackPutter" to make the electric push
rod in the back mode.
③ .
Direction selection, click the button "Out" once to make the stroke of the electric
putter back 2000.
④ .
You need to click the button "Out" 6 times, and the thrust block of the electric
putter can return to the minimum position from the maximum position. In particular,
when you need to stop the operation of the electric putter, you only need to click
the button "Shut down", and the electric putter will be instantly stop working.
1 2 3 4 5 6 7
31
Summary of Contents for Zero
