SET UP
3.9 Clay Pre-extrusion.
1
2
3
Electric putter return operation sequence
Installation matters
Electric putter retracted position state
1.Click the extrusion option on the screen, First select the return ratio "10-200-2000",
then select "BackPutter", and finally click the "Out" option, and return the push rod
motor to the motor side.
Note:
When putter approaching to the side of the motor, please click the "Shutdown"
option to terminate the return, otherwise the motor will be damaged.
PrintPutter
-This
step needs to ensure that each adjustment of the electric putter must be carried out and
cannot be omitted, otherwise it will cause printing failure.
2.Install the cartridge filled with clay in the order shown in the figure above, and
connect the two ends of the cartridge and the extruder with a tube.
3.Description of Extrusion Interface Button Function
Button“Out”: Back Instruction
Button“In”: Forward Instruction
Button“PrePutter”: Pre-extrusion Mode
Button“10-20-2000”: Travel Selection Instruction
Button“PrintPutter”Print Mode
Button“Shut down”Emergency Stop Instruction
Button“BackPutter”Back Mode
Button“Back”: Returns to the Previous Interface
Note:
For detailed explanation of the operation flow of the electric putter to realize
the return function, pre-extrusion, and normal printing, please refer to page 31:
5.1.4
Introduction of electric putter "extrusion" interface.
9
Summary of Contents for Zero
