SET UP
3.10 Levelling the print bed.
3.10.1 The levelling wizard.
4. When a clay is extruded from the needle, select the shutdown option to turn off the
push rod motor and the extruder.
Levelling the print bed and board is arguably the most important step in producing
successful prints and should be checked before every print. Before levelling the Print
Bed board check all springs and thumbwheels are in place.
1. Clean off any excess clay residue from the tip of the needle.
2. Put the board on the print bed and clamp it with clamps.
3. Enter the main interface and select "Leveling "option.
4. In this option ,click "Point1" to move the needle, you can rotate the nut under the
print bed to adjust the distance between the needle and the print bed board. Set 2,3,4,5
point in sequence.
5. On each corner, turn the relevant thumbwheel until you can just slide a piece of copy
paper between needle and print bed board with slight resistance, about 0.1mm.
6. So far the printer leveling is completed.
1
About 0.1mm
11
Summary of Contents for Zero
