KF750
HORN
ASSEMBLY
DISCONNECT RED LEAD +
FROM RED PUSHBUTTON
TERMINAL AND BLACK
LEAD – FROM BLACK
PUSHBUTTON TERMINAL
ON REAR OF DRIVER
10
6.3.1.2
Removing the High Frequency Horn Assembly:
This assembly is heavy. It is made up of a metal bracket, a horn and a driver with 2 elec-
trical leads. The leads must be disconnected carefully.
•
While supporting the assembly, remove the mounting screws that hold the assembly
into the cabinet with a 3/16 allen wrench. These 4 socket head screws, lock washers
and flat washers are indicated by the arrows. Do not discard the mounting hardware.
•
Disconnect the red lead + from the red pushbutton terminal and the black lead –
from the black pushbutton terminal. The terminals are on the back of the driver.
•
Lift the horn assembly away from the cabinet.
NOTE: The high frequency diaphragm is not self aligning. Its replacement requires a
signal/tone generator for alignment. Please contact our factory for further details.
6.3.1.3
Removing the Two Woofers:
The woofer to be removed should rest in the lower half of the cabinet (as shown).
•
Remove the 4 woofer mounting screws with a 3/16 allen head wrench. Do not
discard the mounting hardware.
•
Lift the woofer enough to access and disconnect the two electrical leads. The top
woofer’s red pushbutton terminal has a blue lead+, and its blue pushbutton termi-
nal has a green lead–. The bottom woofer ‘s red pushbutton terminal has a blue
lead +, and its blue pushbutton terminal has an orange lead –.
TOP 12" WOOFER 804091
DISCONNECT BLUE LEAD + FROM
RED PUSHBUTTON TERMINAL AND
GREEN LEAD – FROM BLUE
PUSHBUTTON TERMINAL
4X SCREWS 1/4-20 SOCKET HEAD
CAP 102017 USE 3/16 ALLEN
BOTTOM 12" WOOFER 804091
DISCONNECT BLUE LEAD + FROM
RED PUSHBUTTON TERMINAL AND
ORANGE LEAD – FROM
BLUE PUSHBUTTON TERMINAL
