EauVation Acqua 80, Service Instructions Manual

Page: 22 / 30

Water clock
20
12 Water clock
12.1 Inserting the batteries

Open the battery compartment (1).

Insert two batteries (type AAA). Pay attention to correct polarity of the batteries.

Close the battery compartment (1).
12.2 Setting the capacity

Press and hold down button (2).

Press button (3) with a ballpoint pen tip.
 Release both buttons as soon as “FLI1” flashes in the display.

Press button (2) repeatedly until 8000 litres is shown on the display.

Press button (3) with a ballpoint pen tip to store the value.
 “FLI 2” flashes. Shortly thereafter “OFF”.
 Press button (3) with a ballpoint pen tip to turn off “FLI 2”.
 Proceed the same way for “FLI3” to “FLI5”.
As soon as the set water volume is exceeded, an acoustic signal is triggered.

Confirm with button (3) to reset the alarm.

Replace the hygiene filter.
12.3 Displaying the remaining capacity

Press button (2).

The remaining water volume is displayed.

Press button (2) again.
 “FLI 1” flashes twice.

The remaining capacity is displayed.
12.4 Reset
After replacing the hygiene filter, the consumed amount of water must be reset.

Press and hold down button (3) for 8 seconds.

An acoustic signal sounds.

The consumed water is reset.
12.5 Changing the batteries
Weakening batteries are indicated by an acoustic signal.

Open the battery compartment (1).

Insert two batteries (type AAA). Pay attention to correct polarity of the batteries.

Close the battery compartment (1).