5 Installation
5.4 Mounting
50
MICRO PANEL XV400 5.7"/8.4"
12/2014 MN04802009Z-EN
www.eaton.com
5.4.5
Mounting a device with stainless steel front (mounting to IP69K)
1
Select the mounting position of the device as described in Chapter 5.2.2 Requirements for the
mounting position,
2
Prepare a mounting cutout for the device at the selected position:
Mounting cutout 198
142 mm (±1 mm)
Material thickness at the mounting cutout 6…9 mm
Recess for front plate 212.5 mm (±0.3 mm)
156.5 mm (±0.3 mm)
4 mm
Properties of the mounting surfaces:
Flatness
0.1 mm
(this requirement must also be fulfilled when the device is mounted!)
Surface roughness Rz
6.3 (corresponds to N5)
3
Fit the supplied seal:
The device can also be mounted in a 2…5 mm thick mounting plate. In this case, only
the mounting cutout is prepared. After mounting suitable measures must be taken to
achieve the required sealing in accordance with IP69K.
Abb. 38 Mounting cutout for 5.7" devices
Abb. 39 Seal
198.0
+1/-1
142.0
+1/-1
212.5
+0.3/-0.3
156.5
+0.3/-0.3
4
6…9
A
A
