5 Installation
5.4 Mounting
MICRO PANEL XV400 5.7"/8.4"
12/2014 MN04802009Z-EN
www.eaton.com
45
5.4.3
Mounting a device with 4-hole front
1
Select the mounting position of the device as described in Chapter 5.2.2 Requirements for the
mounting position,
2
Prepare a mounting cutout for the device at the selected position:
Mounting cutout 198
142 mm (±1 mm)
Four through holes ø 4.5 mm, 180 mm (±0.2 mm) and 157 mm (±0.2 mm) apart
Material thickness at the mounting cutout 2…20 mm
3
Mounting the front seal:
3.1
Fit the countersunk screws in the corresponding holes of the device front plate.
3.2
Place the device face down with the countersunk screws.
3.3
Pull off the protective foil from the supplied front seal.
An optional counter frame is required for mounting in accordance with IP65 and for use
in potentially explosive atmospheres. Please contact your supplier.
Abb. 29 Mounting cutout for 5.7" devices
Abb. 30 Front seal fitted
A Front
seal
B Countersunk
screw
157.0
+0.2/-0.2
180.0
+0.2/-0.2
198.0
+1/-1
142.0
+1/-1
ø
4.5
