vi
About this manual
InstructIon manual
MN050011EN August 2022 www.eaton.com
About this manual
This manual describes the installation and commissioning
of the XN300 switch XN-332-5ETH-UMS.
Support center
The latest version of this manual can be found in
other languages by visiting our support center at:
http://www .eaton .eu/documentation
.
Enter the search keyword
XN300
into the quick search or
enter the document designation, e.g., MN050011.
List of revisions
This is the first version of this document, meaning there are
no changes.
Target group
This manual is intended for automation technicians and
engineers.
Extensive knowledge of how to work with the field bus
being used will make it easier to understand the contents of
this manual.
A specialist knowledge of electrical engineering is needed
for commissioning and programming.
Legal disclaimer
All information in this operator manual was provided by us
to the best of our knowledge and belief and in accordance
with the current state-of-the-art. However, this does not
exclude the possibility of inaccuracies so that we cannot
accept any liability for the accuracy and completeness of
the information. In particular, this information does not
guarantee any particular properties.
The devices described here must only be set up and
operated as specified in this manual and in the installation
instructions provided with the device. Installation,
commissioning, operation, maintenance, and refitting
of the devices must only be carried out by qualified
persons. The devices must only be used in the areas
recommended and only in conjunction with third-party
devices and components that have been approved by
us. Only devices and components that are in technically
faultless conditions are permitted. Fault-free and safe
operation of the system requires proper transport, storage,
installation, and commissioning, as well as careful operation
and maintenance. If the following safety instructions are
not observed, particularly with regard to commissioning
and maintenance of the devices by insufficiently qualified
personnel and/or in the event of improper use of the
devices, any hazards caused by the devices cannot be
excluded. We assume no liability for any injury or damages
incurred.
Device designations and abbreviations
XN300 device series, including the XN-312 gateways and
XN300 slice modules.
Writing conventions
Symbols used in this manual have the following meanings:
DANGER
WARNS OF HAZARDOUS SITUATIONS THAT RESULT IN SERIOUS
INJURY OR DEATH.
CAUTION
WARNS OF THE POSSIBILITY OF HAZARDOUS SITUATIONS THAT
COULD RESULT IN SLIGHT INJURY OR EVEN DEATH.
NOTICE
WARNS ABOUT THE POSSIBILITY OF MATERIAL DAMAGE.
