Switching actuators
11
Product descriptions
Descriptions of the products mostly applied are given below. For a complete summary refer to pages 26 and 27.
Actuators
For remote control switching and dimming, each (switching) point to be automated requires an actuator. All these
actuators are provided with an address. Xanura actuators can be mounted in the built-in junction boxes that are
located behind the (switching) points. Depending on the application, actuators suitable for mounting behind wall
sockets or switches are available.
SAX1
switch actuator
Built-in module
Product desciption
The SAX1 is a switching actuator and is mostly mounted
behind wall sockets. In addition, these actuators can be
mounted in central junction boxes, lighting fitments or
housings of electrical appliances. By application of the
SAX1, conventional wall sockets can be energized by
remote control.
Characteristics
•
220V, 16A, suitable for ohmic, inductive and
capacitive loads
•
Can be automatically switched on when a load
is created
•
Can be included in group commands
•
Automatic signalling of status possible
•
Status can be retained after the mains has been
cut off and switched back on again
Operation
The SAX1 can be operated by means of
Xanaru commands sent by Xanura interfaces or
remote control devices.
Installation instructions
•
For wall sockets that are not earthed, a junction
box of 40 mm is sufficient
•
For earthed wall sockets, a junction box of
50 mm is required
Junction
box
Adres
SAX1
Prog.
N
N
L
Prog.
Adres
SAX1
N
N
L
SAX1
2 address
is free for use
switch / pulse switch
Adres
SAIX
Prog.
N
N
L
nd
P
Adres
SAIX
Prog.
N
N
L
SAIX
SAIX
switching actuator/switch interface
Built-in module
Product description
The SAIX is both a switching actuator and switch
interface, that can be mounted in a built-in junction box
located behind light or pulse switches provided with
wiring connected to the associated lighting point. By
fitting an SAIX module, lights (or electrical appliances)
can also be operated by remote control.
Characteristics
•
230V, 16A, suitable for ohmic, inductive and
capacitive loads
•
Can control up to a maximum of 2 consecutive
addresses
•
Can be included in group commands
•
Automatic signalling of status possible
•
Status can be retained after the mains has been
cut off and switched back on again
Operation
The wires of the SAIX module can be connected to a
potential-free switch or pulse switch, so making it
possible to operate it by remote control. The module
has two addresses. The first address switches the live
outlet by energizing the internal relay. The second
address can be used to control another switching
actuator. This address can also, if desired, be used in
combination with the Xanura computer interface (CIX)
to start a (conditional) scenario. The SAIX can also be
operated by means of Xanura commands originating
from other Xanura interfaces or remote control devices.
Installation instructions
•
Phase, neutral and switching wires must be fitted
•
Junction box must be at least 40 mm deep