10
X70 PLUG-IN MOTOR REPAIR MANUAL
E-MOPI-RR009-E—March 2019 www.eaton.com
4. Install the swash plate retainer tool and tight the cap
screw to housing. This will prevent the swash plate fall
out or moving while removing Rotating kit assembly.
Note:- Make sure that the swash plate retaining tool is
touching the forged surface & not damaging the shoe
running face.
5. To remove rotating kit assembly, tilt the motor mounting
fixture 90° as shown in picture. Remove rotating kit
assembly by hand, keep that on table aside.
6. Refer to Appendix A for disassembly and Inspection of
rotating kit.
7. Rotate back the motor mounting fixture to normal
position, remove swash retainer tool & remove
swashplate subassembly from housing and control piston
from swashplate, if needed.
8. Remove Dowel pins from housing.