13
Component Installation
Side Sensor Display Installation
Install the side sensor display where the driver can easily see it. Usually, this will be on the windshield pillar of the vehi-
cle, generally in the same line of sight as the side mirror, so that the driver can monitor both at the same time. If possi-
ble, use existing hardware on the windshield pillar to secure the side sensor display bracket. If existing hardware cannot
be used, drill a mounting hole. The following illustration shows a typical installation.
Before drilling, check for any wiring, hoses and components that may be damaged by drilling and/or mounting
hardware.
1.
The perspective from the driver's seat should determine the proper position of the bracket. If necessary, adjust
the bracket angle by bending the bracket to the desired angle.
2.
Install the side sensor display on the mounting studs, using the two #4 flat washers, two #4 lock washers, and
two #4-40 acorn nuts.
Note: Optional installation - bracket can be flipped over to allow insertion of the bracket between the windshield and the
interior trim.
1 - Side Sensor Display
2 - Self-tapping Screw (optional)
3 - Bracket
4 - Lock Washer
5 - Flat Washer
6 - Acorn Nut
7 - Adjustment Angle
8 - Optional Mounting (top view)
9 - Windshield
10 - Interior Trim
3
1
1
4 5 6
3
4 5 6
10
8
9
7
2
CAUTION
Summary of Contents for VORAD AlwaysAlert
Page 29: ......
