Eaton UltraShift PLUS EO-11E406B-PV, Installation Manual

Page: 88 / 100

82
Line Inspection and End of Line
Line Inspection
This transmission is equipped with a neutral interlock system that when properly installed prevents the engine from cranking
with the transmission in-gear.
Failure to perform installation pre-start checks may result in the engine cranking immediately when ignition is moved to the
“START” position or to the “ON” position.
To prevent undesired vehicle movement for new installations, always set the parking brake prior to turning the ignition key “ON”
and also prior to attempting “START”.
Improper installation of the OEM Start Enable Circuit could result in enabling the vehicle to be started in gear.
Pre-Start Inspection and Initial Starting Requirements
Pre-Start Inspection
• Verify the transmission has been filled with the correct amount and type of lubricant before starting the engine. Failure
to add sufficient lubricant could damage the transmission. See Lubricant Requirement section in this manual for details.
WARNING
WARNING