Eaton STS 2000A, Installation And Operation Manual

Page: 77 / 120

Eaton Static Transfer Switch 2000A 3-Pole Installation and Operation Manual 164001127—Rev 01 61
Figure 24. TIME Screen
Toggle Use SNTP Server to
the green check mark.
Server : set IP address of time
server.
Zone : time zone displaced from
UCT.
Get: initialize time.
Set : confirm date/time.
Save save settings
To have the STS use Simple Network Time Protocol (SNTP), follow these steps:
1. Press Time button at the bottom of the screen. The TIME screen displays ( Figure 24 ).
2. Press the Server button. Enter the time server’s IP address.
3. Press the Zone button. Enter the time zone offset from Coordinated Universal Time (UCT) (-4 is Eastern
Daylight time).
4. Make sure the Use SNTP Server checkbox has a green check. Touch Use SNTP Server to toggle
between the green check (use SNTP Server) and red X (do not use SNTP Server).
5. Press Get to initialize time and verify that Time Synchronization is working.
6. Touch Set to confirm date/time.
7. Touch Save to save settings.
1111..44 S SN NM MP P
The STS supports SNMP over its Ethernet connection. The STS sends a single trap, a summary alarm, if any
alarm condition is raised on the STS. Touch the
SNMP button on the Home Screen to display the SNMP
Screen ( Figure 25 ). Touch MORE to display additional buttons if SNMP button doesn’t show.
System Setup: Networking