Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
11
NOTE
At this point, the DHCP address is saved as a static IP address.
•
If no, go to the
section to manually obtain a static IP address for the
PXGMS card.
NOTE
For detailed information, refer to the
Eaton Power Xpert Gateway Minislot PXGMS UPS Card User’s Guide
.
A
Assssiiggnn aann IIP
P A
Addddrreessss M
Maannuuaallllyy
NOTE
If connecting PredictPulse via an Eaton wireless modem, refer to the document
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton Network Card
rather than this section.
To manually enter a static (fixed) IP address for the card:
1.
Ensure the PXGMS card is still connected over the USB cable and the network cable is connected from the
PXGMS card Ethernet port to the network connection.
2.
If your Web browser already open, go to step 3. Otherwise, perform the following:
a.
Open your Web browser.
b.
Enter:
https://169.254.0.101
for firmware 2.6.0 or later,
http://192.168.200.101
for earlier firmware
versions.
c.
Log on as administrator.
•
For firmware 2.6.5 and higher the username is “admin” and the default password is the card's
MAC address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
Administrator name: admin
–
Password: 00E0D8FFC0C4
•
For firmware versions older than 2.6.5 the default username and password is “admin”.
The PXGMS card Web page displays.
3.
Select
Network
from the
Configuration
menu. The
Network
page displays (see
