Eaton Power Xpert Gateway 200E, User & Installation Manual

Page: 83 / 212

CHAPTER 8 - PXG200E CONFIGURATION WEB PAGE
75 EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835
7. If there is more than one Bus in the system, select the Bus to which the
new device will be added
(Figure 72, A) .
NOTICE: Remember that this example is installing an IQMESII
meter point so make sure the bus you choose has an IQMESII
submaster installed on it.
Figure 72
8. Click on the button (Figure 72, B) to proceed to Step 10 if you are
satisfied with your selection.
9. Click on the button (Figure 72, C) to go back to Step 3 if you wish
to change the selection.
10. Select the type of device from the “What is the Device Type” drop-down
menu
(Figure 73, A) . Note that for this example IQMESII meter
point is the only choice that is compatible with the Meter Point
that was chosen in
Step 4 .
11. Click on the button (Figure 73, B) to proceed to Step 13 if you are
satisfied with your selection.
12. Click on the button (Figure 73, C) to go back to Step 3 if you wish
to change the selection.
Figure 73
PXG200E_242
A
C
B
PXG200E_243
A
B C
RETURN