Operating instructions ResistTel IP4/IP162
03/22
29
4.3.3.2
Transfer (Put a call through)
By initiating the transfer by pressing the key , you initially remain connected to your call partner A and
the telephone asks you to enter the subscriber number for subscriber B, whom you want to connect to
your call partner A. After the entry has been made and the key has been pressed, the switching
process starts. Your original conversation partner A calls the subscriber B you have selected, you your-
self have ended the call and can hang up the receiver.
Initiated transfer
Dial subscriber B
Idle mode
1
Indicates the numeric mode of manual input (dialling preparation)
Indicates that headset operation is turned on in the menu
Indicates the connection status to the gatekeeper
-------------- Dialling ---------------
Manual dialling. Enter the subscriber number using the numeric keys. In this operating mode
you can enter digits and text characters and correct the entry if necessary. Finally, press the
right arrow key to start the transfer process.
or
callback. The list of incoming calls will open, from which you can use the and keys to
select the caller you want to connect to your partner A. Finally, press the right arrow key to
start the transfer process.
or
redial. The list of outgoing calls will open, from which you can use the and keys to
select the caller you want to connect to your partner A. Finally, press the right arrow key to
start the transfer process.
4.3.4
Other
4.3.4.1
Subscriber numbers
Your phone can dial not only normal subscriber numbers, but also H.323 names and IP addresses.
Contains a participant number other than the digits 0-9 | * | # other characters, so it is interpreted as
H.323 name. A preceding @ sign in H.323 names is automatically removed before dialing.
Manual input in immediate dialling mode
This mode only supports entering the characters 0-9 | * | # from the numeric keypad and dials charac-
ters as you type.
Manual input in dial preparation mode
This mode supports the input of numeric and text characters, allows the correction of input errors and
dials the entered character string en block if you indicate the input as complete by pressing the key
. This mode is identified by a small, inverted box in the lower right corner of the display. The box
indicates whether the input is currently in number mode
1
or in text mode
a
|
A
is located. Switch to
text mode
1
>
a
, e.g. by holding down the key until the first text character in the character list asso-
ciated with the key appears on the display. Press the key in quick succession to replace the current
character "|a" with the next character "|b" from the list. Wait until the cursor moves from the left to the
right side of the last selected character "b|" to finally accept the character. The return to digit mode
a
>
1
occurs when your character selection ends on a digit or you press the key .
