Eaton i-on Style, Manual

Page: 9 / 12

Page 9
Partition 1 S
Partition 2 U
“U” = unset
“P” = part set
“S” = set
b) Press

or

to highlight the
partition, then

or

to select the
change you want:
Partition 1 S>U
Partition 2 U
“U>P” = change unset to part set
“U>S” = change unset to full set
“S>U” = change full set to unset
“P>U” = change part set to unset
c) Repeat step b) as required.
d) Press

.
Managing alarms
If there is an alarm, you will need to
silence the sirens and sounders (if they are
still running), acknowledge the cause of the
alarm and reset the system.
Note: Please refer to the Administration
and User Manual for full details.
To silence, acknowledge and reset an
alarm:
1. Make sure that it is safe to enter the
premises.
2. Enter your access code or present your
proximity tag in the normal way. This
silences the alarm (if the sirens and
sounders are still operating).
Note: In a partitioned system, you can
silence, acknowledge and reset an
alarm only if it has been caused in a
partition to which you have access.
3. The navigation key glows red and
the display shows the alarm(s). For
example:
P1:Burg Z001 Alarm
P3:Burg Z002 alarm
Reset
OR:
Call Installer
P1:Panel lid open
P2:Panel lid open
P3: Panel lid open
P4: Panel lid open
P1, P2, P3 and P4 are the partition
numbers. If applicable, the display
alternates between showing the zone
number and name.
4. If you see “Reset” in the bottom-right
corner (see above):
• Press

− this acknowledges the
alarm and resets the system. The
system returns to standby and is
ready to set again. The navigation
key returns to its normal (green)
state.
If you see “Call Installer” or “Call ARC”
at the top of the screen:
• Press

− this acknowledges the
alarm, but you will need to call the
installer or ARC to reset the system.
Although the system is not reset, you
will still be able to set and unset the
system normally. The navigation key
and applicable set/unset icons stay
red until the alarm is reset.
Accessing the User menu
The User menu gives access to user
options such as to omit zones, view log
information and add new users. The range
of options available to you depends on
your user type (privileges).
To access the User menu:
1. Make sure the display shows the
standby screen.
2. Press

(important).
3. Enter your user code:
Enter Access Code
V v v v