Product Information
Introduction
DT400/436 Tee Connector Kit from Eaton's Cooper
Power Systems is a premoulded separable connector
designed for connection of polymeric (XLPE, EPR, etc.)
cable to transformers, switchgear, motors and other
electrical apparatus. It can be used indoors or outdoors
in installations up to 36 kV requiring a continuous current
rating of 630 A or less, where the mating bushing
complies with CENELEC standard EN50180, Interface C.
Read This Manual First
Read and understand the contents of this manual and
follow all locally approved procedures and safety practices
before installing or operating this equipment.
Additional Information
These instructions cannot cover all details or variations
in the equipment, procedures, or process described nor
provide directions for meeting every possible contingency
during installation, operation, or maintenance. For
additional information, contact your representative.
Acceptance and Initial Inspection
Each elbow is in good condition when accepted by the
carrier for shipment. Upon receipt, inspect the shipping
container for signs of damage. Unpack the elbow
and inspect it thoroughly for damage incurred during
shipment. If damage is discovered, file a claim with the
carrier immediately.
Handling and Storage
Be careful during handling and storage of the elbow to
minimize the possibility of damage. If the elbow is to be
stored for any length of time prior to installation, provide a
clean, dry storage area.
Standards
ISO 9001 Certified Quality Management System
Figure 1. 630 A deadbreak bolted tee connector.
1
DT400/436 tee connector installation instructions
MN650001EN September 2014 www.cooperpower.com
