Installation Leaflet
Page 30 Effective: April 2003
Pow-R-Command 100
IL01412003
For More Information visit www.cutler-hammer.com
7-2 ADDRESSING USING A POCKET PC
TEST TOOL
The most convenient means of adding
(addressing) controllers to a network is
with the Pocket PC Test Tool. This is a small
hand-held device with software duplicating
some functionality of the Management
Software. This device connects directly to
the 4-Pin Network Test Port on a controller.
Refer to SECTION 4 to identify both the
controller type and location of the Network
Test Port. The size and connectivity of this
device preclude the need for a second
person as with the PC procedure described
above.
Adding a controller to the network with the
Pocket PC tool is slightly different from the
PC version. The Pocket PC tool is used to
first locate the controller needing an
address. A connection is then established
with the controller and the address is
manually entered in the system table. The
following steps briefly describe this
procedure:
STEP 1:
Connect the network test tool to
the four-pin test connector on the controller
(or nearby networked controller).
STEP 2:
Launch the Utalk application on the
Pocket PC.
STEP 3:
The unit will search the network
for connected (already addressed) devices
and display a list of controllers found as in
Figure 7-4.
STEP 4:
Use the stylus to tap the “View”
menu item in the lower left corner of the
screen
STEP 5:
Tap the “Find Controller…” menu
option. This will present another screen
prompting you to press the RESET button
on the controller you are trying to find
(Figure 7-5). Refer to Section 4 to identify
the controller type and location of the 4-Pin
Network Test Port.
STEP 6:
Within 15 seconds of pressing the
RESET button on the controller, tap the “Find
Controller” button on the screen. The Test
Tool will now attempt to connect to the
desired controller and will then report the
device address.
Figure 7-5: Screen Shot From Hand-Held PC Software For Configuring New
Pow-R-Command 100 Controller
Figure 7-4: Screen Shot From Hand-Held PC Software For Configuring New
Pow-R-Command 100 Controller
