![Eaton Cuttler-Hammer Pow-R-Command 100 Instruction Leaflet Download Page 2](http://html1.mh-extra.com/html/eaton/cuttler-hammer-pow-r-command-100/cuttler-hammer-pow-r-command-100_instruction-leaflet_3838355002.webp)
Installation Leaflet
Page 2 Effective: April 2003
Pow-R-Command 100
IL01412003
For More Information visit www.cutler-hammer.com
Pow-R-Command System
Installation Leaflet
Notes and Warnings
-Read this guide completely and carefully prior to any installation. Failure to follow the instructions or the
prescribed procedures may cause severe injury or death and/or damage to the equipment.
-All installation and service must be performed by qualified personnel or service technicians. Keep this guide
available to those responsible for installation, programming, operation, and maintenance of the system.
-All installation and wiring information contained herein is based on industry-accepted standards and practices.
This information is not meant to conflict with or overrule any applicable codes or ordinances. If any conflicts
exist, please contact your Cutler-Hammer Representative before proceeding with the installation.
-USE EXTREME CAUTION WHEN OPERATING THE SYSTEM. DANGEROUS VOLTAGES MAY EXIST
INSIDE THE UNITS.
Failure to follow any or all warnings and instructions contained herein may cause severe
injury or death and/or damage to the equipment.
-Panels are shipped from the factory with the electronic boards installed and tested. Many of the electronic
components may be sensitive to static electricity.
Do not
handle electronic parts without proper electrostatic
protection.
-Document all wiring, device termination and locations. This information will be required for system start up and
programming.
-Under no circumstances switch on the power to the electronics during or after installation. Power up,
programming and system configuration should be performed by qualified personnel during the system start up.
-The instructions and prescribed procedures in this Installation Guide do not purport to cover all possible
contingencies, which may arise during installation, and all details and variations of the system. If further
information is desired by regarding the particular installation of the system, please contact your
Cutler-Hammer Representative.