34
Manual CEAG CG-Controller for CG 2000/ZB-S
30080001458 (C) July 2016 www.ceag.de
11 LED displays
11 LED displays
11.1 LED indicators
“Ready for operation”
“Test mode” and “Failure”
11 .1 .1 Control module (LED displays)
11 .1 .1 .1 Ready for operation
The front plate of the CG-Controller shows the
“Ready for operation” state with a green LED.
•
LED green on = The entire „Emergency
lighting“ system is ready for
operation.
11 .1 .1 .2 Test mode
The front plate of the CG-Controller shows the
“Test mode” state with a yellow LED.
•
LED yellow on = One or more emergency
lighting systems arein test
mode.
11 .1 .1 .3 Failure
The “Failure” status is indicated by a red LED.
•
LED red on = One or more emergency
lighting systems are reporting
a failure.
12 Secure-Digital-Memory
Card SD
12.1 Device configurations
12 .1 .1 Configuring devices
with SD
You can use the «Setup device» / «Dev. config.
←
SD» menu item to configure devices.
This configuration can then be transferred to the
devices with the Secure-Digital-Memory Card
SD (see Figure 2).
12 .1 .2 Reading the device config-
uration and saving to SD
You can use the «Setup device» / «Dev.
config.
→
SD» menu item to save the device
configuration to the Secure-Digital-Memory
Card (see Figure 3).
12.2 Logbook
Logbook entries are retrieved by the system on
a regular basis. Entries that are read are saved
on the SD of the CG controller.
If no SD is plugged in, the logbook is located in
EPROM.
Table 5: LED indicators
No:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
One or more
emergency lighting systems
Manual reset
Functiontest
Durationtest
Deep discharge protection
Block
Operation
Mains failure of UV S3/S4
Mains failure of UV RS485
Mains failure of device
RS485 transmission fault
Battery failure
Converter failure
Charge-/isol. failure
Luminaire failure
Not enough capacity
Battery operation
CG-S bus communication failure
Ready for operation
LED green on
X
X
X
X
X
X
Test mode
LED yellow on
X
X
Failure
LED red on
X
X
X
X
X
X
X
X
X
X
X
X
X
X
