13
Manual CEAG CG-Controller for CG 2000/ZB-S
30080001458 (C) July 2016 www.ceag.de
9 Menus
9 .2 .2 .1 Conditions for switching off cyclic
data reception
If one or more of the following conditions are
met, the polling machine will be switched off.
• The Search for devices process is active
• The Battery voltage menu is active
• Read network configuration
• Write network configuration
• Read/write network device luminaire text
• The Circuit status menu is active
• DLS_TLS_3PHW menu is active
• The Luminaire status menu is active
• Device selection menu in Info device
• Add devices menu
• Read CG-Controller configuration
• Write CG-Controller configuration
• Info menu active
• Read new CG-Controller configuration from PC
-> CG-Controller
• New network device configuration from PC
-> Device update
9 .2 .3 LCD back lighting
When a key is pressed, the display is lit up for
about 3 minutes.
9.3 Main menu
9 Menus
9.1 Menu overview
You can use the «Menu» key to bring up the
main menu
.
The table on the following page gives an over-
view of the overall menu structure.
9.2 Main screen
Operation:
You can use the Menu key to switch
to the main menu.
Variable displays can be set to italic in the LCD
displays.
If no device fault is present, Line 3 is empty.
Status and fault messages (Lines 2 and 3) are
shown with the same priority as described
in Section 6.1 and 6.2. The message will be
displayed if at least one system has this fault/
status. “Operation” is only displayed when all
systems are reporting “Operation”. “Logbook
active” or “Logbook saving” can also be dis-
played in Line 4.
9 .2 .1 Jump back to the main
screen automatically
If no key is activated in a submenu for about 3
minutes, the system automatically switches to
the main screen.
9 .2 .2 Cyclic data reception of
emergency lighting systems
The information from the emergency lighting
systems is read cyclically. This information is
required for the status and fault display, the
relay and the logbook.
Line
LCD display:
1
Software CG 2000/ZB-S
2
Status display
3
Fault display
4
1
3:29:17
26.10.2002
1
Test menu
n
2
Block, reset
3
Info device
4
Setup CG-Controller
etc.
Menu
Back to main screen
n
= current cursor position
