SM64200
February
2007
20
Notes:
1. Refer to SM44646, SM60129-1 and 47013, as appropriate, for detail information. * Add
pressure rating to part number to complete it. The type of hose end control valve used depends
upon the rest of the options ordered.
2.
Refer to SM44315 for detail information. On screen add mesh size 40, 60 or 100 in lieu of “**”
to complete part number. On 44317-* add correct dash number (1-6) to complete part number.
3.
Refer to SM349MISC for detail information.
4.
Refer to SM64001 or SM61154 for detail information.
5.
Refer to SM40679 for detail information.
6.
Refer to SM64015 for detail information.
7.
Refer to SM64001 or SM61154 for detail information.
8.
All part numbers beginning with "GF" are interchangeable with those beginning with either
"AN" or "MS". If three numbers follow the "GF" it is interchangeable with an "AN" part; otherwise it
is interchangeable with an "MS" part of the same number.
9.
Kits so noted can be combined, e.g. 64200-1-2 to obtain complete kit to fit the particular
nozzle in use. However –2 through –4 are exclusive and only one can be used in any one-part
number.
10. These kits are designed to allow one to order a combination kit as noted in note 9 above only.
If either the KD64200-5, -6 or –7 Kits are to be ordered use KD44646-1, KD47013-1 or KD60129-1
respectively.
11. Item 23 O-ring is made of flurosilicon (blue in color) to facilitate closure of the poppet. This
material is softer and does not swell when exposed to fuel. Due to its softer makeup, it also wears
faster than Nitrile compounds. A suitable alternative would be Carter’s 201201-148, which is a low
swell Nitrile compound that will wear longer but will present a larger closure force. The use of a
standard Nitrile O-ring will lead to much greater closure forces and not present a significant
increase in life. It is not recommended for these reasons. The basic nozzle was tested in
accordance with the latest SAE Commercial and Military Specification AS5877 with the blue O-ring
and it passed without a problem. This entailed several thousand connections and opening and
closing cycles and should represent months of service.
12. A kit that will include the harder 221014 Pin and other parts needed to install it is now
available as KD64200-9.
Conveyance Systems Division
Carter Ground Fueling
671 West 17th Street
Costa Mesa, CA USA 92627-3605
Ph: (949) 764-2200
Fax: (949) 631-2673
Summary of Contents for Carter 64200
