28B
28A
Página 12
Página 27
Hip Supports
64. The hip support width can be adjusted by
loosening the knobs behind the pelvic pad.
Adjust to desired position and tighten
securely.
65. To adjust the fore/aft positioning on the
hip supports, loosen the thumb knobs and
put in desired position. Adjust to desired po-
sition and tighten securely.
Lateral Supports
66. The lateral support width and height can
be adjusted by loosening the knobs on the
back of the unit. Adjust to desired position
and tighten securely.
67. The lateral supports have a number of
attachment holes on the back of the pad
which will allow for additional positions
vertically and horizontally. The pads may
also be bolted at a high, low, or neutral
position for greater pad range.
28
66
65
67
64
28A. If the optional chest strap was ordered,
place it around the pad as shown.
28B. Position strap in the grooves on the
support bracket as shown.
29. If the Prone model was ordered follow
steps 29-35, remove the cap on the support
tube and discard. A flat screw driver may be
needed.
30. Using a hex wrench, loosen the set
screw some, but do not remove.
29
30
Tilt Table
Prone
Prone
