EASTMAN Blue streak II 629X, Instruction Manual And Parts List

Page: 18 / 40

14
EASTMAN
Form C-1555
PROBLEM SOLUTION
Machine does not a. Surface of cutting table not
move easily on table smooth
b. Rubber mounted rollers com-
pressed causing baseplate to
drag on table
No bevel on one side a. Broken torsion spring
of blade b. Band plates do not pivot
freely
Sharpener belt cut a. Refer to page 8, Checking the
off by blade Extreme Down Position of the
Sharpener
Pressure foot rod a. Dirt in pressure foot lock
does not move freely bracket
Pressure foot rod a. Lock loose on shaft
does not hold b. Pressure foot handle spring
broken
c. Teeth worn on lock
d. Screw loose
Sharpener runs a. Oil on crank
slowly b. Stabilizer assembly too tight
against standard
c. Worn pulley
d. Worn screw shaft
e. Add grease to lower gear
bracket
Bevel very wide on a. Worn sharpener shoes
both sides of blade
Troubleshooting
PROBLEM SOLUTION
Motor overheats a. Cut out switch not engaging
properly
b. Lint and dust inside motor
cover
c. Three-phase: one phase not
working
Machine does a. Connector not firmly attached
not start to terminal pins
b. Start switch defective
c. Starting switch or cut-out
switch and/or capacitor
defective
Bottom corner of a. Knife slides badly worn
blade breaks b. Knife strikes throat plate.
Motor slow to attain a. Sharpener is engaged
top speed b. Cut out switch not adjusted
properly
c. Low or wrong voltage
d. For three-phase machines:
1. Fuse out on one phase
2. Ground wire incorrectly
connected to machine
Motor slows in a a. Crosshead and guides tight
certain position b. Standard not in alignment
with crosshead
c. Standard bent
Motor rotates in a. Three-phase: incorrect wiring
wrong direction
Terminal block and/or a. Inserts in connector worn.
electrical connector
Change connector.
overheats b. Terminal pins worn