EASTMAN Blue streak II 629X, Instruction Manual And Parts List

Page: 10 / 40

6
EASTMAN
Form C-1555
WARNING
This machine is equipped with a very sharp knife. Re-
move the knife when working in this area. Failure to keep
hands, arms, and hair away from the knife area may result
in serious personal injury.
4. Remove the back guide (Figure 3).
5. Press the lever (Figure 3, E) to a neutral position and
raise the sharpener to the top (original) position.
6. Remove the four hold-down nuts (Figure 3, V) and
remove the sharpener.
Note: If you press the sharpener lever (Figure 3, E)
down too far (beyond the neutral position), it will lock
the sharpener bracket. If this occurs, lift the release
lever (Figure 3, D) and start over again.
D release lever
E sharpener lever
V hold-down nut
X plate bolt nut
Figure 3. Removing the Sharpener
Replacing the Rubber Driver Pulley
The sharpener is driven by a rubber driver pulley, as shown
in Figure 4. Replace this driver pulley whenever it appears
to be worn or damaged, as follows:
1. Remove the sharpener from the machine (see Remov-
ing the Sharpener on page 5).
2. Press the sharpener lever (Figure 3, E) to a neutral
position and lower the sharpener until an inch of the
square shaft (Figure 4, W) is exposed.
W square shaft
Figure 4. Replacing the Rubber Driver Pulley
3. Hold the square shaft with a wrench. Position the wrench
as close as possible on the shaft to the sharpener
housing.
4. Use a spanner wrench to remove the driver pulley
by turning it clockwise as indicated by the arrow in Figure
4.
Note : The pulley has a left-hand thread.
5. Reassemble the new pulley on the sharpener.
6. Reassemble the sharpener on the machine.
BACK GUIDE
X