Plasmasonic
®
DRSSTC Instruction Manual
December 2019, REV -
− 34 −
http://www.EasternVoltageResearch.com
Plasmasonic
®
1.3 DRSSTC Instruction Manual
At no time should anyone approach the Plasmasonic system while the unit is
plugged in and only approach the system after 5 minutes have passed once the
system is unplugged from the AC line power.
5. Set the Pulsewidth ADJ on the handheld controller to the minimum setting.
This is done by turning the PW knob all the way to the left counterclockwise.
The handheld controller should be OFF at this time.
5. The Frequency ADJ knob on the handheld controller as no effect on MIDI
operation, however we always recommend that this knob be turned to zero prior
to powering up the handheld controller.
6. Switch the MODE switch to the MIDI position.
7. Ensure the handheld controller power is OFF.
8. Plug in the AC power cord to an appropriate 120VAC outlet which is rated for
at least 20A. Again ensure that all individuals and pets are safely away from the
Tesla Coil per the recommend safety layout shown above in Figure 6. Once the
unit is plugged in, you should see the LED illumination turn on (if equipped) and
the two (2) cooling fans should be operating. The LED on the power distribution
board should be illuminated as are the two green STATUS LEDs on the
Advanced Controller module.
Please ensure that a non-GFCI outlet or circuit is utilized when operating the
Plasmasonic DRSSTC system. This unit will not operate properly when using
Ground Fault Circuit Interrupter (GFCI) outlets or circuit breakers.