3
3)
METHOD OF ATTACHMENT TO FORKS
Before installation of the type WP Work Platform onto a Forklift, ensure that the fork arms
are suited and set to the correct width.
The type WP Work Platform is supplied with the rear (top) frame wired to cage for ease of
transport
.
Fig. 3.1.1
To install the type WP Work Platform:
a)
Unwire the rear (top) frame from its transport position within the cage.
b)
Remove the M10 nut and bolt sets from the rear of the cage. Referring to
Fig. 3.1,
slide the tube spigots of the rear frame into the corresponding holes situated on the top
rail at the rear of the work platform cage. Secure in position by replacing the two M10
nut and bolt sets into their original positions and tighten.
Note: If the rear frame is to be removed often, grease the spigot to prevent seizing.
c)
Position the forklift with the fork arm engaged into the slippers as shown in
Fig. 3.1
.
With the fork arm shank (vertical face) firmly against the rear of the WP Work
Platform, slide the two locking pins supplied through the slipper.
d)
Before using the type WP Work Platform, the rear frame must be in position as
stated above
.
WARNING
: In accordance with Australian Standard
AS2359.6, the following attachment information shall
be added to the manufacturer’s “Identification Plate” on
the Industrial Truck;
•
type of attachment,
•
weight of unladen truck in working condition
fitted with attachment,
•
Capacity of truck and attachment combination at
maximum elevation.
Slide Rear (top) frame into
position, and fix with two M10
nut & bolt sets supplied.
(Refer Fig. 6.1)
Insert two Locking
Pins (SP-0024) supplied.
