7
Threading Bobbin Case
Place
bobbin
into
bobbin case.
Make sure the thread unwinds in
the direction of arrow.
RaIse take-up lever to its highest position by turning balance wheel toward you.
Raise presser foot.
Place spool on spool pin as shown, with thread coming from the back of the spool.
1.
Draw thread into thread guide using both hands.
2.
While holding thread near spool, draw thread down into the tension area and then around
the check spring holder.
3.
Firmly draw thread up and through take-up lever from right to left.
4.
Then draw thread down and slip it into the lower thread guide.
5.
Draw thread down and slip it into needle bar thread guide.
6.
Thread needle eye from front to back.
NOTE:
You may want to cut the end of thread with a pair of sharp scissors for easier needle threading.
Switch on the power after threading the machine and bobbin. Your are now ready to sew.
Pull the thread into the bobbin
case slot.
Draw the thread under the tension
spring and into the delivery eye.
* Leave aboust 10 cm (4 inches) of free
thread.
Threading the Machine
Always thread your machine with the power off
1
2
3
4
5
6
2
1
3
4
6
5
3
4
5
PDF created with pdfFactory trial version
www.pdffactory.com