20
STEP 10
Installing the Hydraulic Fittings
1] Remove the red plastic plug from the pressure port. Install the hydraulic O ring “elbow” fitting
into this port. Wind the fitting in by hand until the O ring is up against the face of the pump and
the elbow is pointed down. Hold the fitting in this position with a wrench and tighten the jamb nut
with a second wrench until the washer compresses the O ring. Do not use Teflon tape.
STEP 11
Installing the Hoses
1] Connect one end of the short hydraulic hose to the elbow fitting at the pump. Connect the
other end of the hose to the fitting at the base of the main side cylinder. Do not use Teflon tape.
2] Connect each end of the long hydraulic floor-hose to the short-fitting at the inside base of each
cylinder. Route along the floor, to lie between the equalizing cables, beneath the floor-plate. Do
not use Teflon tape.
(Fig. 13A)
