11
INSTALLING THE HARDWARE
STEP 2 - MOUNTING THE LINK ARM AND DOOR MOUNT BRACKET
TIP UP TYPE DOOR
(refer to diagram on page 10)
Locate and mark the center position
of the spine (top edge) of the door.
Figure 11.1
.
While holding the door mount bracket in place on the centre position, mark
the mounting hole positions.
Using your 5mm wood drill bit, drill pilot holes into the door spine where you
have just marked the door.
Fasten the door mount bracket to
the door, using your 13mm spanners
and/ or wrenches and 2 of the M8 x
40mm coachscrews (for other types of
doors, use recommended fixtures).
Figure 11.2
Fasten the link arm to the door mount bracket, using your 13mm spanners
and/or wrenches and 1 of the M8 x 25mm hexagonal bolts and M8 Nylock
nuts.
Be certain not to over tighten the nut and bolt as the link arm must be able to
swing freely up and down in the door-mount bracket.
When you have completed the above, move on to Step 3 - Determining the
mounting position and mounting of the drawbar front-end.
A=B
A
B
