Version 1.1
8. Assembly guide
8.1 Take out the bike from the original packaging
①
Remove all the parts from the original packaging. Check if the parts are damaged before assembly.
②
The seatpost, saddle and handlebars are tied to the Ebike, and the front wheel is tied to the front fork legs.
(Use scissors to cut the cable tie for assembling use) In addition, there are pedals, charger, charger cable
and assembly tools in the cardboard box.
8.2 The front wheel
①
Tear off the front fork packaging and install the front wheel on the front fork.
②
Pay attention to the orientation of the front wheel: the front wheel disc is on the same side as the front fork
disc brake seat. Make sure that the axle is attached to the front fork on both sides.
③
Install the quick release, loosen the screw, the quick release handle should be on the same side as the
disc brake. On the other side, install the spring and nut.
④
Tighten the nut and turn the quick release handle upward tightly, Make sure that the quick release handle
is firmly in place and that the front wheel is locked.
⑤
After the front wheel is assembled, turn the front wheel manually to check whether the front wheel rotates
smoothly.
8.3 The handlebar and seatpost
①
Hold the seatpost upright and pre-lock the upper screws of the stem.
②
Loosen the 4 screws of the front cover of the stem, then take the handlebar and put it into the stem to lock
the handlebar, pay attention to the corresponding middle position of the handlebar (left and right hand side
should be at equal distance from the center of the stem), and correct rotation angle of the handlebars.
Tighten the screws of the front cover of the stem.
③
Rotate the handlebar to make sure that the handlebars are perpendicular to the direction of the front
wheel. This will ensure that the stem and direction column are well aligned. Tighten the upper screws of the
stem.
9
