5. Remove the stabilizer and cut a notch in the
rudder to allow for the elevator joiner wire.
6. Place the joiner wire into the notch cut in the last
step. Slide the stabilizer back into position. Check
the alignment of the stabilizer, and then use foam
safe CA to glue the stabilizer to the fuselage.
17
Summary of Contents for thunderbolt p-47
Page 1: ...P 47 Thunderbolt Assembly Manual...
Page 18: ...7 Glue the joiner wire and hinges using foam safe CA 18...
Page 44: ...Notes Notes 44...
Page 45: ...Notes Notes 45...