29
Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 2
Place the second wing joiner against the glued
surface of the first. Align the edges of the two joiners
then clamp them together with binder clips. Use
a paper towel moistened with rubbing alcohol to
remove any epoxy that squeezes out. Allow the glue
to dry completely.
□□
Step 3
Apply low-tack tape to the servo leads where they
exit the top of the wing to hold them out of the way
while the panels are being joined.
□□
Step 4
Install the nylon wing bolts halfway into their holes in
the trailing edge of the wing panels.
□□
Step 5
Mix approximately 1/2-ounce of 30-minute epoxy
in a mixing cup. Use a mixing stick to apply it to the
inside of the wing joiner slots in each wing panel and
to the face of the root rib on one side only.
□
Step 6
Slide the wing panels together onto the joiner.
Once the epoxy is mixed, pour it onto a
flat surface such as a paper plate or scrap
piece of cardboard to prevent it curing
prematurely. This will allow enough time
to apply the epoxy where needed before it
starts to set.
