5
6
Additional Safety Precautions and Warnings
As the user of this product, you are solely responsible for operating it in a manner that does not endanger yourself
and others or result in damage to the product or the property of others .
This model is controlled by a radio signal that is subject to interference from many sources outside your control .
This interference can cause momentary loss of control so it is advisable to always keep a safe distance in all
directions around your model, as this margin will help to avoid collisions or injury .
• Never operate your model with low transmitter batteries.
• Always operate your model in an open area away from cars, traffic, or people.
• Avoid operating your model in the street where injury or damage can occur.
• Never operate the model out into the street or populated areas for any reason.
• Carefully follow the directions and warnings for this and any optional support equipment (chargers, rechargeable
battery packs, etc .) that you use .
• Keep all chemicals, small parts and anything electrical out of the reach of children.
• Moisture causes damage to electronics. Avoid water exposure to all equipment not specifically designed and
protected for this purpose .
• Never lick or place any portion of your model in your mouth as it could cause serious injury or even death.
Blade CX3 MD 520N RTF Contents
Item
Description
Not Available Separately
Blade CX3 MD 520N RTF Airframe
EFLH1055
LP5DSM 5-Channel Transmitter, DSM 2 .4GHz
EFLB0990
7 .4V 800mAh 2-Cell Li-Po, JST/Balance
EFLC3110
2-3 Cell Li-Po Balancing Charger, 0 .65A
EFLC4000
AC to 12VDC, 1 .5-Amp Power Supply
EFLH1209
Mounting Accessories & Screwdriver
EFLH1022
Bind Plug
FUG4 (Optional)
4 AA batteries
EFLH2009 (Optional)
MD520N LED Navigation Light Upgrade Set
Additional Required Equipment
No additional equipment is required to complete your Blade CX3 MD 520N .
Preparing for the First Flight Checklist
Please note this checklist is not intended to be a replacement for the content included in this instruction manual .
Although it can be used as a quick start guide, we strongly suggest reading through this manual completely before
proceeding .
q
Remove and inspect contents
q
Charge the flight battery
q
Install the 4 included AA batteries in the transmitter
q
Install the flight battery in the helicopter (once it has been fully charged)
q
Check the Center of Gravity of the helicopter
q
Test the controls
q
Install the optional Training Gear Set (EFLH1205; strongly recommended if this is your first helicopter model)
q
Familiarize yourself with the controls
q
Find a suitable area for flying
Flying Checklist
Please note this checklist is not intended to be a replacement for the content included in this instruction manual .
Although it can be used as a quick start guide, we strongly suggest reading through this manual completely before
proceeding .
q
Always turn the transmitter on first
q
Plug the flight battery into the 3-in-1 control unit
q
Allow the 3-in-1 control unit to arm properly
q
Fly the model
q
Land the model
q
Unplug the flight battery from the 3-in-1 control unit
q
Always turn the transmitter off last
