Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual
4-15
Radio Wide Features
Each scan list can be selected as User Editable. With this option selected, the user can edit
the active scan list only from their radio. The user can also select which scan list is active
through a programmed function button or menu function selection. This active scan list is
retained through power down.
4.13.2.1
Determining Channels in Radio Wide Scan List
The channels can be determined only by selecting the scan list edit mode (see “Editing
Radio Wide Scan List” which follows).
When the displayed channel is in the scan list (scanned normally), the symbol is
displayed next to the zone number as shown in the following illustration (Standard Control
Head). The
is displayed at the top of the screen for the Lightning Control Head.
.
4.13.2.2
Editing a Radio Wide Scan List
If the RWS Edit option switch is programmed, the radio wide scan list can be edited.
Changes are permanent (cycling power does not reselect a default condition). Proceed as
follows:
1
Make sure that both priority and radio wide scanning are OFF. Select the scan edit
mode by pressing the RWS Edit option switch. This mode is indicated by a triangle in
the upper left corner of the display (see Figure 2.3).
2
Select the channel you want to add or delete by rotating the Select switch. A single
beep sounds when the channel is changed (if that option is enabled). After the last
channel in the current zone is displayed, the first valid channel in the next zone is
displayed and vice versa. The list is limited to 255 channels. If an attempt is made to
add more than 255, “LIST FULL” is displayed and a channel must be deleted before
another can be added.
3
If the selected channel is in the scan list (scanned), “
R
” and the symbol are displayed
next to the zone number for the Standard Control Head. If the selected channel is in the
scan list, the
is displayed at the top of the screen for the Lightning Control Head. To
change the scan list status of the displayed channel, press the Select switch. A single
beep sounds when the switch is pressed (if that option is enabled).
4
To exit this mode and save the changes, press the RWS Edit option switch again.
Scan List Indicator
Channel
Number
