C H A P T E R 2
Cable Routing
DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
2-14
4
For dynos with the Linx option:
4a
Strip a 1/4-inch of the housing off the wires.
4b
Attach the butt connector from the relay 85 to the green brake signal wire.
4c
Attach the butt connector from the relay 86 to the white brake signal wire.
Figure 2-12: 4WD Movement Board—Connect Speed Pickup/Brake Wires with Linx Option
5
Place the speed pickup/brake cable (F) from the 4WD dyno in the cable track.
6
Close the crossbars on the cable track links.
7
Route the cable track back underneath the dyno.
8
Secure the cable track to the front rail tie assembly using the two 1/4-20 x 1-inch
hex-head screws and two washers removed earlier.
9
On the stationary dyno, locate the two black brake solenoid leads. These wires
were disconnected from the Breakout board earlier.
10 Clip the ferrules off the brake solenoid leads, strip a 1/4-inch of the wire and
crimp one of the sockets (P/N 44359120) onto each wire.
11 Insert the sockets into the housing (P/N 44329902). The position of the sockets in
the housing is not critical.
12 Attach the two-pin connector on the speed pickup/brake cable (F) to the
connector on the brake solenoid wires.
