C H A P T E R 4
Pre-Run Inspection
DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
4-10
PRE-RUN INSPECTION
Perform a vehicle inspection before making a run.
• Check the radiator coolant and oil levels.
• Check the fuel source.
• Rotate the drum(s) and check for rocks caught in the tire tread that could fly out.
• Check the tire pressure and tire speed rating. Improperly inflated tires or exceeding
the maximum speed rating can result in premature wear or severe tire damage.
Make sure the tire has no major deficiencies (cracks in sidewalls,
tread life, etc.).
• Visually inspect the vehicle. Make sure it is in safe running order.
• Make sure ear protection and safety glasses are used when the dyno is being
operated.
• Check the tie-down straps to make sure that they are tight and secured.
• Check the drive tires to be sure that they are aligned correctly on the dyno drums.
• Keep all rotating components clear at all times.
• Only the operator should be near the dyno or the vehicle during the test.
• Never allow any person(s) to stand behind the dyno or vehicle when it is being
operated.
• Perform any other safety inspections appropriate to running your vehicle on the
dyno.
Never allow any person(s) to stand behind the dyno or vehicle when it is
being operated. Only the operator should be near the dyno or the vehicle
during the test.
B
EFORE
S
TARTING
THE
E
NGINE
Connect an exhaust hose or hoses (if dual exhaust) on the vehicle, make sure the hose
fits over the tail pipe, is not plugged or kinked and the hose is vented correctly out of
the dyno room.
Engine exhaust contains poisonous carbon monoxide gas. Breathing it
could cause death. Operate machine in well ventilated area.
