![background image](http://html1.mh-extra.com/html/dynojet/dynoware-rt/dynoware-rt_installation-manual_2550824053.webp)
3-19
M O D E L 4 2 4 D Y N O W A R E R T U P G R A D E W I T H E D D Y C U R R E N T B R A K E
Cable Routing
Version 5
DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
R
EMOVING
THE
D
YNO
W
ARE
EX C
ABLES
1
Remove the two 1/4-20 x 1-inch hex-head screws and two washers securing the
cable track with the signal wires to the front rail tie assembly.
Note:
If your air hoses are routed through the same cable track, you will need to
disconnect them from the stationary dyno. Be sure to note or mark the air hose
positions before disconnecting the hoses. The hoses must be reconnected in the
same position.
2
Pull the cable track out from under the dyno.
3
Using a screwdriver, open the crossbar on each link.
Figure 3-15: Open the Crossbar
4
Disconnect each torque cell cable from the DynoWare EX (hardware stack).
5
Remove the 4WD dyno torque cell cable from the cable track. Coil this cable up
and place it near the 4WD dyno.
6
If not already done, disconnect the stationary and 4WD temperature sensor cables
from the TEMP FROM DRUM 1 and TEMP FROM DRUM 2 terminals on the
Breakout board. Do not disconnect the sensors from the eddy current brake.
7
Remove the 4WD temperature sensor cable from the cable track. Coil this cable up
and place it near the 4WD dyno.
AD079
cable track
link
crossbar
use screwdriver
to open