C H A P T E R 2
Load Cell Calibration
Torque Cell Installation Guide for Model 250i/250iP DynoWare RT Dynamometers
2-6
If you do not have enough room to use the bolt pattern closest to the end of the
calibration arm, use the bolt pattern in the center of the arm as shown in
Figure 2-6 for above ground dynos and for Figure 2-7 in ground dynos.
Figure 2-6: Install the Calibration Arm and Weights Using the Bolt Pattern in the Center—Above Ground Dyno
T 075
M
weights
weight support pin
secure arm to brake by
tightening handle
